Does a harder ceramic always resist breakage better?
No. Hardness describes resistance to local indentation or scratching, toughness concerns crack growth and fracture, and stiffness concerns elastic deformation. Mark thin walls, hole edges and assembly loading points on the drawing so these requirements can be assessed separately.
Can a thermally conductive ceramic also be electrically insulating?
Yes. Aluminum nitride combines these properties. Thermal conductivity describes heat transfer, thermal expansion describes dimensional change with temperature, and electrical insulation is a separate requirement. Check each against the grade and operating conditions.
Is every silicon carbide grade suitable for EDM?
No. EDM requires suitable electrical conductivity; the SiC name or a description of semiconducting behavior does not establish compatibility. Provide the specific grade and resistivity information or measurements before assessing the equipment and sample evaluation.
Why identify whether the blank is green, pre-sintered or fully sintered?
The processing stage affects available operations and dimensional control. For powder forming and sintering routes, shaping before firing must allow for shrinkage, while machining afterward addresses final dimensions and surfaces. Provide the current condition, allowance and final drawing together.
Can grades with the same chemical name share one machining process?
Not automatically. Feedstock, additives and manufacturing methods can change material behavior. Use the actual grade, supplier information and representative samples rather than the material family name alone.
What comes first when comparing grinding, laser machining and EDM?
Start with material condition, part features and acceptance requirements. Evaluate profiles, dimensions and surfaces for grinding; surface features or cutting for laser machining; and conductivity first for EDM. Workholding, tooling and sample results guide the final route.
Is machine positioning accuracy the same as accuracy on my part?
A machine specification is not a part acceptance result. Material, geometry, workholding, tools, process and inspection all contribute. Evaluate samples against agreed dimensions, geometric tolerances, surface requirements and measurement methods.
What information is needed before machine-selection trials?
Prepare a revision-controlled drawing, the actual material grade and blank, critical features and acceptance methods. State the trial samples, target production output and machine implementation plan. Agree on trial operations, inspection conditions and records so the results can confirm the model, configuration and application conditions.